Generator controller - DEIF AGC200
Controller DEIF AGC200 is the genset control module: it runs start and stop, watches oil pressure, temperature and speed, and commands the transfer when mains fails.
Controllers fail three ways: moisture and creeping corrosion on the terminals, transients on the control supply, and display wear. Typical symptoms are intermittent starting, phantom low-oil alarms, or a screen that stops responding.
Specifications and compatibility
- Brand
- DEIF
- Model
- AGC 200
- Dimensions
- 380 x 265 x 125 mm
- Weight
- 3.00 kg
How to verify before ordering
- The reference must match the installed module. Identical size does not mean identical wiring: input map and transfer logic change between versions.
- Confirm the supply voltage (12 V or 24 V) and the number of inputs and outputs your panel actually uses.
- If the panel has an expansion module or remote communication, check that the new controller supports the same protocol.
- The reference shown on this listing is AGC 200; cross-check it against the one stamped on the removed part.
Frequently asked questions
Can it be installed without reprogramming?
No. Every new controller needs configuration: rated voltage, frequency, crank and cooldown timers, and transfer logic. We ship the factory configuration; site parameters are set on commissioning.
Does the controller include the display?
Where module and screen are one piece, yes. If your panel uses a separate display, check the full reference before ordering, because they are sold separately.
Related parts
- CONTROLADOR AMF-20
- CONTROLADOR AMF-25
- CONTROLADOR 3110+ AUTO MPU
- CONTROLADOR DSE 6020 MKII
- CONTROLADOR DGS9510N
See the spare parts catalogue or request a quotation quoting the equipment reference. Third-party trademarks are cited for identification purposes only.
Specifications
| Brand | DEIF |
| Model | AGC 200 |
| Dimensions | 380 x 265 x 125 mm |
| Weight | 3,00 kg |